Your Swing Should Pick the Clubs, Not a Rack
Divot Lab builds every fitting around your own launch-monitor numbers, backed by a decade of in-house club-building experience. Driver through putter, what you leave with is measured and built for your motion — never the other way around.
The Whole Bag, One Club at a Time
Every fitting session starts the same way: your current equipment, your swing data, and an honest conversation about what you actually want to get out of your golf.
Driver Fitting
Dial in launch angle, spin, and shaft profile to add distance and tighten your start-line off the tee.
Learn more →Iron Fitting
Match lie, loft, length, and shaft flex across the set for tighter dispersion and cleaner gapping.
Learn more →Wedge Fitting
Bounce, grind, and loft gapping tuned to your turf and the shots you actually hit around the green.
Learn more →Fairway Wood Fitting
Confidence off the tee and the deck with heads and shafts built around your attack angle.
Learn more →Hybrid Fitting
Close the long-iron gap with a hybrid that launches high and lands soft, sized to your set.
Learn more →Putter Fitting
Length, lie, loft, and face balance measured against your actual stroke, not a fitting chart.
Learn more →A Fitting That Actually Moves the Needle
Stock clubs are built for an average golfer who doesn't exist on any real course. Your height, swing speed, tempo, and attack angle are all yours — and even a couple degrees of lie angle or the wrong shaft flex quietly costs accuracy and distance every round.
We run a Doppler-radar launch monitor, a full demo fleet across major manufacturers, and an in-house build shop, so your new clubs are cut, built, and ready to play — usually inside a week.
- Independent fitters — no single brand's quota to hit
- Every swing logged, not just your best three
- In-house build shop for fast turnaround
- Fitting fee credited toward any club purchase
| Club | Carry | Gap |
|---|---|---|
| 7-Iron | 158 yds | — |
| 8-Iron | 147 yds | 11 yds |
| 9-Iron | 135 yds | 12 yds |
| PW | 121 yds | 14 yds |
| GW (50°) | 106 yds | 15 yds |
Four Stops Between Your First Swing and New Clubs
Interview & Goals
We start with your bag, your typical misses, and what you want the new clubs to actually fix.
Launch Monitor Session
Hit real shots with your current clubs and demo heads while every swing gets logged.
Spec Recommendation
We walk through head, shaft, length, and lie/loft options backed by your own numbers.
Build & Verify
Clubs are built in-house and confirmed on our frequency machine before you pick them up.
What Golfers Say After a Session
Added 10 yards of carry with the driver and my miss pattern shrunk noticeably. The shaft decision was obvious once I saw the numbers — no upsell involved.
Never been iron fit before this. My old set was 3° flat and I had no idea. Ball flight is a completely different picture now.
Full bag rebuild with a fitter who actually listened to what I wanted. Gapping is finally clean from wedge to driver.
Ready to See What Your Numbers Say?
Sessions run 60–90 minutes and end with a full written report. Fitting fees are credited toward any club purchase built in our shop.